richc
Peloton Rider
Posts: 172
|
Post by richc on Dec 7, 2016 9:54:41 GMT
Has anyone managed to find some aero / tri bars to fit a original T3 with its fat centre section of handlebar?
|
|
|
Post by r0b1et on Dec 7, 2016 10:03:34 GMT
|
|
|
Post by goffski on Dec 7, 2016 10:06:29 GMT
|
|
richc
Peloton Rider
Posts: 172
|
Post by richc on Dec 7, 2016 12:26:28 GMT
Thanks for the replies guys. I did try some Decca ones a few years back but they were too small, the middle of my bars is thicker than 31.8mm, they slim down to that about 70mm from the centre. I don't know if the bars on a 60cm frame T3 would be a bigger diameter than normal.
|
|
|
Post by r0b1et on Dec 7, 2016 12:37:03 GMT
Thanks for the replies guys. I did try some Decca ones a few years back but they were too small, the middle of my bars is thicker than 31.8mm, they slim down to that about 70mm from the centre. I don't know if the bars on a 60cm frame T3 would be a bigger diameter than normal. That's very very odd. any normal bar will go the other way around and get narrower away from the clamp point. Not just the tape?
|
|
|
Post by robertsims on Dec 7, 2016 14:23:33 GMT
|
|
richc
Peloton Rider
Posts: 172
|
Post by richc on Dec 8, 2016 18:36:14 GMT
Thanks for the replies guys. I did try some Decca ones a few years back but they were too small, the middle of my bars is thicker than 31.8mm, they slim down to that about 70mm from the centre. I don't know if the bars on a 60cm frame T3 would be a bigger diameter than normal. That's very very odd. any normal bar will go the other way around and get narrower away from the clamp point. Not just the tape? Yes that what I ment, thicker at the clamp point. But just been out with a vernier gauge and the centre of the bars is 31.8mm ish so I think I was suffering from an optical illusion. Sorry for wasting everyone's time, I will try one of your recommendations.
|
|